Witajcie przyjaciele, używam tłumaczenia. Przepraszam. Nie mam przycisku zwalniania bagażnika w moim samochodzie. Chcę go podłączyć. Czy jest ktoś do pomocy?
To jest widok strony w wersji do druku
Witajcie przyjaciele, używam tłumaczenia. Przepraszam. Nie mam przycisku zwalniania bagażnika w moim samochodzie. Chcę go podłączyć. Czy jest ktoś do pomocy?
Maybe in English it will be simpler: You don't have internal? In theory in batch of wires passing through the the car inside, probably on the left side under the doors and further towards the rear of car,one of the wire is connected with outer opening switch. You need to find it by electrical measurement and/or by color which you should be able to see at the outer switch. Then at the body computer you can duplicate this wire and lead it to central console and put there another switch.Cytat:
Napisał tsburak61ts
Cytat:
Napisał marx30
Thanks for your answer, my vehicle has a trunk release button on the central console, but there is no outer button, I'm trying to add it, I checked the installation, there is no cable for the outer button in the trunkhttps://uploads.tapatalk-cdn.com/202...8c953eeed8.jpg
Aaah that's we have opposite situation ;-). So you need to take wires from switch in central console and draw it to rear trunk ;-). But rather it needs to check if somebody can not open trunk when the car is closed (I did not investigated how it works).
I thought of taking the button on the center console but when I lock the doors from the center console, the trunk hurts from the button on the center console, if I buy additional, the trunk will open when the doors are locked, so I'm looking for which pin is the original bcm because on 2019 models, there is a button in the trunk in the originalCytat:
Napisał marx30
Thanks for the answer, but I tried socket F 29 pin +5 volt - when it touches it drops to 0 volts, but the trunk does not open I wonder if it is active from bcm.Cytat:
Napisał JackTheNight
This option in alfaobd you muss change :
Trunk Door: Enabled
Trunk Type: Lift Gate
And this if you want:
Remote Trunklid Release Button: Release
I tried it too but it didn't work but I'll try againCytat:
Napisał JackTheNight
It had settings you said. I just the remote trunklid release button is not active, this time I activated it, the controller did not open the trunk, I closed it again, the remote control turned on but the F29 did not work. Could There Be another SettingCytat:
Napisał JackTheNight
maybe you connect to wrong pin in socket, maybe not F29 , check this and be sure that is F29.
no i'm sure i connected it right. but where does the F30 connect in the project. I have F30 emptyhttps://uploads.tapatalk-cdn.com/202...259689cfe5.jpgCytat:
Napisał JackTheNight
P093 this is antena for remote control.
But I think I know the solution.
When you disconnect the battery and reconnect this button
the trunk opening does not work and this is normal.
You must first close the car with the remote control and then open the car with the remote control. Only then does the switch on the tailgate work and you can use it to open the tailgate. Only then give the mass to F29, of course the car must be opened with the remote control and not closed.
and it is important how to connect the battery first
use the remote control. close and open the car with the remote control. Then on opened car, the button, entering the mass on F29 should work.
Thank you.Cytat:
Napisał JackTheNight
I will try it too
I did as you described, again it didn't work. I add pictures of the socket. Doesn't BCM support this?toohttps://uploads.tapatalk-cdn.com/202...35a7146a90.jpgCytat:
Napisał JackTheNight
https://uploads.tapatalk-cdn.com/202...b3f2963060.jpg
https://uploads.tapatalk-cdn.com/202...ab845bd2d4.jpg
https://uploads.tapatalk-cdn.com/202...6e4e1d0f9e.jpg
Czy udało się komuś dołożyć przycisk bagażnika? Niestety w tipo tipo bardzo mi tego brakuje. Dołożyłem przewód do pinu 29 wtyczki F. Występuje na nim napięcie +5V. Niestety po połączeniu z masą efektu brak. Opcje w alfaobd tj. Trunk Door: Enabled oraz Trunk Type: Lift Gate, fabrycznie były ustawione, więc nie było konieczności ich zmiany.
musisz jeszcze ustawić opcję :
Trunk Button Location : Both Internal and External
I jak odpinasz akumulator i podpinasz ponownie, to najpierw musisz zamknąc auto pilotem i otworzyć pilotem.
Po tym przycisk bagażnika powinien działać już poprawnie.
Zmiana tej opcji, to pierwsze co zrobiłem po powrocie z urlopu ;)
Działa! Dziękuję, masz u mnie piwo JackTheNight jak się spotkamy. Teraz muszę jeszcze dołożyć fizyczny przycisk na klapę.